Polyamide resin
PA resin
Name Of Products: POLYAMIDE RESIN
CAS NO. 63428-84-2
Type : Alcohol soluble polyamide Resin;
Co-solvent Type Polyamide Resin (also named Benzene Soluble polyamide resin)
Appearance: Light yellow granular or crushed form.
Characteristic:
1. Benzene soluble polyamide resin is developed accommodating to the market requirement. It has good stability, good solvent liberation, strong bending flexure, marvelous glossiness, strong adhesive power, fine gel resistance and indoor temperature turn-frost, widely used in various printing ink.
2. Alcohol soluble polyamide resin is a kind of new developed resin, used for anastatic printing ink, which has good alcohol soluble property, marvelous compatibility with nitrifying cotton, as well as the high gloss index and marvelous adhesive power for the printed matter. It can be used for all kinds of solvent-based printing ink
Usage: It is used in gravure printing ink, flexibility anastatic printing ink, heating seal
beaded paint, gloss oil, adhesive, painting, coating,etc.
Specifications :
ITEM Benzene soluble Alcohol soluble
Amine Value (mgkoH/g)---------------5 max ----------------- 6 max
Acid Value (mgkoH/g)-----------------5 max ------------------ 6 max
Viscosity(CP/25 ) ---------------------80-270 ------------------ 80-280
Softening Point ()----------------------100-120 ---------------- 110-125
(Remark: 1. Solution Viscosity measured in 40% Nv with Toluene and IPA ( 73 ) as solvent;
2. we could control the range of viscosity to small range as customers request);
Packing:In 25kg bags craft paper bag.
Introduction:
We are manufactures of low cost and high performance dimer acid based hot melt polyamide adhesives. We can deliver offsets to Henkel, Bostic and Arizona at prices that are $2 to $4 per lb., depending on the grade and color requirements. We can also tailor small batches of unique grades of HMPA to meet your specific requirements (minimum 2 ton order quantity) at these same competitive prices.
How do we do this? We have been working in this industry for more than 20 years and have dimer acid manufacturing capabilities that give us performance and economical advantages. We are also a lean company focused only on manufacturing, sales and performance technology - our competitors have more Vice Presidents than we have employees.
So tell us what you want:
Are you happy with the current grades you buy but want to save money and/or have a second source?
Faster or slower open time?
More flexibility, elongation or impact?
Higher or lower softening point?
Thicker or thinner material?
Any combination of the above?
Better pot life/stability?